This set matches the Upper Case set.
Simply cut strips of fondant approximately the width of the letters. The fondant strip should be placed vertically and the letter cutter will be perpendicular to the fondant. Press down on the cutter and move around your board to achieve a clean cut. You then simply tap out and the letter will fall on to your board. Use a cocktail stick to pick out any parts of the letters that you don’t need.
- Food Approved Plastic – BPA free
- Each letter is approximately 1.5cm high
- Full ‘how to’ instructions on back of pack
- Lower Case Letters on 2 Strips
Always use a good quality modelling paste rolled thinly and allowed to dry for a few minutes for best results. If using Sugar paste add a little Tylo or CMC to strengthen the paste and speed up drying
**For useful tips & tricks for all FMM products check FMM’s FREE RESOURCES section**